Categories

False alarms and system malfunctions can be exasperating, and even worse, may prevent your security system from doing its job effectively. Fortunately, most issues, from false alarms to dead batteries, are straightforward to remedy. Take a look at our recommendations for troubleshooting your home alarm system in Salt Lake City. We’ll help you keep your household shielded and your system operating smoothly.

Test Your Home Security System In Salt Lake City

One sensible way to troubleshoot your home’s security is to test it! The latest systems have a test mode so you don’t by accident prompt an emergency response. After moving to test mode, take these steps:

• Turn on your system as you typically would when you exit your home.
• Open a window or door that uses a contact sensor, or try to trip something else. Shut the door or window once you’re finished so it doesn’t trigger the alarm when you reactivate the system.
• Permit the alarm to resonate for 60 seconds to make sure a signal is sent to the security company and an entry is made in the alarm activity log.
• Proceed to test devices as needed
• Check the alarm’s activity log to verify that everything’s working.

Don’t worry, monitoring agents can see that your alarm system is involved in a test. Just make sure to turn test mode off when complete. It’s smart to test every other month or whenever you change your home’s internet or phone connectivity.

Inspect The Positioning And Condition Of Motion Detectors

Although an integral element of your alarm system, motion detectors are notorious for false alarms. You can help prevent them with a few straightforward troubleshooting steps.

• Perform a physical inspection. Is there anything that could move within the sensor’s detection range, like a window treatment blown in a breeze?
• Is the sensor dirty? Grime, dirt, and cobwebs can cause poor performance. Check to confirm the device is clean.
• Does the motion detector offer pet immunity you can activate? Some can be programmed to disregard pets up to 100 pounds.
• When was the battery replaced? A nearly depleted battery can impact performance or cause false alarms.
• Is a heat source impacting the sensor? Excess heat from sunlight or a fireplace can set off an alarm.

Keep Batteries Ready And Watch Out For Low Battery Signals

One helpful benefit of the latest home security systems is that they’ll alert you when batteries are dying. If your system uses a app or control panel, you’ll typically find messages there. Depending on the alarm, you might notice an intermittent beep when batteries are low. 

Motion detectors, smoke detectors, contact sensors, and other wireless tools have batteries that need to be replaced every so often. It’s best to keep batteries around and create a replacement schedule. Many systems also include a rechargeable backup battery for the central control panel. This backup battery keeps your system functioning if your power goes out and should recharge once power is back online. If it fails to recharge, you will have to replace it.

Troubleshooting Is Effortless With ADT Home Security In Salt Lake City 

As the leading name in home security, ADT designs systems that supply unrivaled functionality and convenience. Getting into test mode is simple through MyADT.com or the ADT+ app, and you’ll always be sent updates when a sensor battery is running low. Contact Secure24 Alarm Systems, an authorized ADT dealer, to get more details and design a system perfect for your Salt Lake City home and family. Place a call to (801) 895-2509 or fill out our form today!